Uncoiler routine maintenance

To uncoiler life more lasting, we need to carry out routine maintenance it carefully, follow these steps:
1, according to the requirements of each cup oil lubrication and artificial lubrication points refueling.
2, according to the parameters specified Uncoiler uncoiler conduct Coil, Coil thickness of 20mm, the maximum length of 2500mm, coil material is less than the yield limit 250Mpa.
3, after the power is turned on the next roll on roll both directions and down movement, check there are no unusual movements stuck phenomenon.
4, in strict accordance with uncoiler coil processing procedures and operating methods of operation, when the roller lift to the limit position, we must pay great attention to the safe operation of the equipment.
5, when the main drive after shutdown before proceeding to lift the roller bearing dumping reset flip and tilt on a roll.
6, during operation, if found irregularities with irregular noise, impact, etc., should immediately stop checking.
7, the operation of each staff to coordinate with each other, listen to the person in charge of directing coil, there is no password, prohibit start the machine.
8, conducted uncoiler coil operation should pay great attention to the hand being pressed steel plates together and roll into.
9, with the lifting plate or reel while driving, be careful not to collide with the machine.
After unwinding machine work, do work completed, materials to make the site clean and good equipment maintenance work, be turned off.

Cut to Length Line is used in the Metal materials cutting.

Hangzhou Yibo Machinery Co.,Ltd, founded in 2003 is an professional machinery manufacturer for design, produce, service and trade.

Yibo's main products are Cold Roll Forming Machine, such as purlin Forming Machine , guardrail forming machine, roof panel forming machine, wall panel forming machine, tile forming machine, floor Deck Forming Machine, Roof Seaming Machine and so on; steel coil process machinery such as Slitting Line , cut to length line, combined line and so on; accessory Stamping Parts such as roof supporting clips, connect bar, water bar and so on.

Cut to Length Line

Cut to Length Line,Cut to Length Machine,Cut to Length Line Machine,Cut to Length Process Line

HANGZHOU IUWON TECHNOLOGY CO,. LTD. , https://www.iuwon.com